How to add a printer
Please follow the steps below to add a printer to your device. By adding the printer in this way, you will be able to print and then 'release' the print from any printer in the school, by visiting the printer and either swiping your ID card on the reader or signing in with your printer code. If you don't know your printer code please log a ticket here. You are also able to print while off-site, and then can release the print when you are physically on-site.
1. On your device, open Edge or Chrome and visit this URL: https://tinyurl.com/hgsprint/
You should be presented with the following page:
2. You may be presented with the following prompt straight away. If you are, please click on 'Open':
3. If the above prompt doesn't open, or you close it by mistake, you can click on 'Connect and get my printers', as shown in the image in step 1.
4. You should then see the following pop-up message in the bottom right of the screen:
5. Then the following message:
6. At this point, the printer has been installed. You can now print from any application or software as normal. Please ensure you choose 'Colour_Printer [PServer02](Mobility)' from your list of printers.
7. When you print, you may be prompted to enter your username and password, as shown below. You can enter just the short username, without the full '@holmegrange.org', for example, b.smith.
8. You should then receive a confirmation message in the bottom right of the screen confirming that your print was successful. You can now visit a printer and release the print as normal.
